P3 International P3 E9310 User Manual download pdf (Page 11)

11. FCC Information

FCC ID: RNT-PT3

Changes or modiﬁcations not expressly approved in writing by P3 Inter-

national Corporation may void the user’s authority to operate the equip-

ment.

NOTE:

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful in-

terference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to

radio communications.

However, there is no guarantee that interference will not occur in a par-

ticular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the inter-

ference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

The internal antenna used for this mobile transmitter must provide a se-

paration distance of at least 20 cm from all persons and must not be

co-located or operating in conjunction with any other antenna or trans-

mitter.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions:

(1) this device may not cause harmful interference,

and

(2) this device must accept any interference received, including in

terference that may cause undesired operation.

1 2 ... 6 7 8 9 10 11 12

No comments

P3 International P3 E9310 User Manual Page 11