P3 International P3 E9310 User Manual download pdf (Page 6)

5. Preparing for operation

5.1. Open the housing

- Rotate the unit and unscrew the 6 screws (see below)

- Lift up the upper part carefully.

5.2. Inserting the batteries

- The unit is operated with 3 x 1,5 V AA batteries. Use alkaline batteries

for longer life and better protection against leaking.

- Insert the three batteries into the battery holder with right polarity as

shown in the battery holder.

- If you want to make settings (addresses or measuring unit), go to the

next chapter.

- Finally, close the housing. Be sure the temperature sensor is placed in

the correct position in the housing and most importantly that the neopre-

ne seal ring is aligned properly before you close the housing and tighten

the screws. Tighten the screws carefully in a diagonal sequence.

5.3. Setting address and measuring units

Display

Screws

Batteries

Sensor

Eye for fixing

on the ground

1 2 3 4 5 6 7 8 9 10 11 12

No comments

P3 International P3 E9310 User Manual Page 6